International 
Clay paint
Warm white interior paint for walls and ceilings on mineral substrates (such as clay, gypsum, lime and cement plaster, masonry and concrete), woodchip wallpaper, mineral-based paint fleece, firmly adhering and absorbent emulsion and mineral paint finishes, plasterboard and gypsum fibreboard, and similar substrates. It helps to regulate the moisture content of the indoor air, thereby promoting a comfortable indoor climate.
- good coverage
- moisture-regulating and breathable
- Easy to apply with a roller or brush
- vapour-permeable
- solvent-free and plasticiser-free
- free from ingredients of animal origin
- Contrast ratio: H₁₀ Class 2 with a coverage of 7 m²/l
- Wet abrasion resistance: Class R 4 in accordance with DIN EN 13300
- Gloss level: G3 matt
- Max. grain size: S1 fine
Container sizes: 1 piece(s)
Pallet: 40 piece(s)
Item no.: 066603401
EAN: 4007955666134
Pallet: 40 piece(s)
Item no.: 066603401
EAN: 4007955666134
Technical data sheet
Area of application
Warm white interior paint for walls and ceilings. Moisture-regulating, ideal for use on mineral substrates, woodchip wallpaper and plasterboard.Preparation
The substrate must be dry, clean and sound. Remove any old paint that is not firmly adhering, distemper and loose plaster. Pre-treat highly absorbent, sandy and chalky surfaces with proMineral primer.Processing
Stir the clay paint thoroughly before use and apply it with a brush, roller or a suitable spray gun. Apply two coats if necessary. The first coat may be thinned with a maximum of 10 per cent water. The top coat should be applied undiluted once the first coat has dried thoroughly. Do not apply when the substrate or room temperature is below +5 °C. Clean tools with water immediately after use.Tinting:
For coloured finishes, the clay paint can be tinted with a maximum of 4 per cent universal tinting concentrates (LW-Oxyd types only) or with proMineral coloured paints.
Drying time:
Under normal conditions (20 °C, 65% relative humidity, moderately absorbent substrate), the drying time is approx. 6–12 hours. Under unfavourable conditions (e.g. low temperature or high humidity), the drying time may be extended.
Consumption
1 litre is sufficient for approx. 6–8 m² with a single coat – depending on the condition of the substrate. Determine the exact amount required by carrying out a test application on the surface.Storage
Store containers tightly sealed in a cool place, but away from frost. Do not allow the product to enter the sewer system, watercourses or the ground. Only send completely empty containers for recycling. Dried-out residues can be disposed of with household waste or as construction site waste.Notes
Keep out of the reach of children. Due to the high pH value, avoid contact with the eyes and skin. It is recommended that you wear gloves and safety goggles (not glass). In case of skin contact, rinse thoroughly with plenty of water. In case of eye contact, rinse immediately with plenty of water and seek medical advice if necessary.Please refer to the safety data sheet for safety-related information. Up-to-date safety data sheets are available on our website www.pro-mineral.com.
EU VOC limit value for this product (Cat.: A/a, Wb) = 30 g/l (2010). Maximum VOC content of this product: 0.5 g/l.